Tensioned strap pulley system to raise and lower the shutter. Simple and economical. Can be operated on the same side of the shutter or fed through the wall, the coiler box is fixed internally at a convenient point.
Motors require standard UK 240V power and require space for accompanying control point. Available options include wired rocker switch, wired key switch and remote controls. The cabling outlet point is specified when configuring your shutter.
Motors require standard UK 240V power and require space for accompanying control point. Manual override available as direct input or through the wall input, specified when configuring your shutter.
Our configuration tool runs with 3 installation types for made to measure roller shutters:
Roller facing outward, guide tracks fitted in between the opening. Required recess depth of at least 23mm for guide channels. Fixed at the guides, which support the roller box on top.
Guides and box flush with the opening surround. Box depth can not exceed the depth of the recess. Fixed at the guides, which supports the roller box on top. L shaped guide tracks recommended for easy install.
Box and guide tracks mounted on the façade around the opening. Wall space for box (up to 180mm) and guides (53mm each side) necessary. Fixed at the guides, which supports the roller box on top.
|TOTAL SHUTTER HEIGHT =||BOX HEIGHT x DEPTH
|Up to 1499mm||137 x 137mm|
|Up to 1799mm||150 x 150mm|
|Up to 2299mm||165 x 165mm|
|Above 2300mm||180 x 180mm|
After choosing your installation type, take 3 sets of measurements of the structural opening and specify the smallest set. Our technicians adapt your roller shutter according to your specified installation type, accounting for the box and guide tracks.